Results 1 to 4 of 4
  1. #1

    Question (Chester) See image and notes

    Hi Chester, I talked to you about carb tuning, but see only one screw on each and it is very limited by how much it turns because of the extruded part on the plastic end (screw).
    I have a book on pre 1998 models, but the carbs aren't the same.
    So I'm not sure what this screw is/does or what to do with it.
    I'll call you and ask that you look at the image.
    Thanks .)

  2. #2

    Default

    Image reference attached:
    Attached Thumbnails Attached Thumbnails carb1.jpg  

  3. #3
    Member Chester's Avatar
    Location
    Surrey, BC Canada
    PWC
    98 SXi Pro
    Posts
    125

    Default

    That's a limiter cap. Just pop it off.

    Chester
    4 out of the 5 voices in my head say, pull the trigger!

    Chester

  4. #4

    Default

    Got it all worked out and will put them back on the ski first chance I get. Pretty sure it will run, but may need you to look it over if I detect a problem.
    Thanks so much Chester .)

Similar Threads

  1. Chester need help?
    By Gotham in forum Kawasaki
    Replies: 4
    Last Post: 04-25-2009, 08:51 PM
  2. Paging Chester...jetting question, SLX
    By SideFX in forum General PWC Chat
    Replies: 2
    Last Post: 02-15-2009, 03:21 PM
  3. Attn. Chester
    By ColdFusion in forum General PWC Chat
    Replies: 6
    Last Post: 03-17-2006, 03:41 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •