Hull gelcoating question

[Norton]

Hi guys,
I want to gelcoat, wet sand and then polish the complete hull of my Seadoo RX-DI because it look like the previous owner did a lot of beaching and the bottom of the hull is pretty scuffed up and I want to clean it up. Nothing structural, it's just for the esthetics.
My question is to get total access to the bottom of the hull can you basically stand the unit up vertically on the back end or can this damage the unit? If not, what is the easiest way to get acces to the repair the complete hull?

thanks,
Norton

[MRK]

remove the battery, most of the fuel and oil. Then pinch all oil and fuel lines and flip the PWC upside down and start fixing the hull!

[Norton]

Thanks for the info MRK !

Norton