Results 1 to 3 of 3
  1. #1
    Member
    Location
    Stittsville, Ontario
    PWC
    RX-DI & SSxi
    Posts
    3

    Post Hull gelcoating question

    Hi guys,
    I want to gelcoat, wet sand and then polish the complete hull of my Seadoo RX-DI because it look like the previous owner did a lot of beaching and the bottom of the hull is pretty scuffed up and I want to clean it up. Nothing structural, it's just for the esthetics.
    My question is to get total access to the bottom of the hull can you basically stand the unit up vertically on the back end or can this damage the unit? If not, what is the easiest way to get acces to the repair the complete hull?

    thanks,
    Norton

  2. #2
    Member MRK's Avatar
    Location
    Mississauga,ONT
    PWC
    KAWI X2, GP1200
    Posts
    109

    Default

    remove the battery, most of the fuel and oil. Then pinch all oil and fuel lines and flip the PWC upside down and start fixing the hull!

  3. #3
    Member
    Location
    Stittsville, Ontario
    PWC
    RX-DI & SSxi
    Posts
    3

    Default

    Thanks for the info MRK !

    Norton

Similar Threads

  1. 92 Kawi 750SX Hull material question
    By Nooovie in forum Kawasaki
    Replies: 1
    Last Post: 07-04-2010, 01:36 PM
  2. 2008 KAWASAKI 800 SX-R Question
    By Dega in forum Kawasaki
    Replies: 2
    Last Post: 02-10-2010, 10:43 AM
  3. Insurance Question
    By sunfire50 in forum General PWC Chat
    Replies: 0
    Last Post: 08-16-2007, 04:13 PM
  4. Water sensor question ? ?
    By GTX94 in forum Sea-Doo
    Replies: 0
    Last Post: 05-22-2007, 04:20 PM
  5. Transport question
    By Grizz in forum General PWC Chat
    Replies: 6
    Last Post: 04-04-2006, 10:45 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •