Results 1 to 4 of 4
  1. #1

    Default old scool parts mostly kawasaki . attn Canadians cheaper shipping within Canada

    - used yamaha 701 standard bore and rings from good running engine $40 for the set including used wrist pins
    - yamaha 650 , 701 stator $120

    - yamaha 650 / 701 flywheel $70 fit 6m6 71x both off a 6m6 650
    - Yamaha 650 E box complete from running ski may now need relay .. $140 (cdi will also work on a 701 but lower rev limt )




    - kawasaki 440/550 aftermarket kerker exhaust pipe head pipe and two chambers one short one longer clean shiney chrome chambers black headpipe .. needs silicone or rubber coupler ..
    $100 or $80 with one chamber ..

    - 440 stock kawasaki exhaust manifold $25 ( will not sell separate unless pipe sells first )
    - 650 stock kawasaki exhaust manifolds $30
    - 750 stock exhaust manifolds
    - 750 exhaust from a750sx model complete with exhaust manifold $70
    - over bore NEW piston kit with rings for a 440 kawasaki WSM .5 over $40
    -replacement hood strap for a 440 or 550 kawasaki jetski $25
    - handle pole / hood / hull engine mounts etc from a 440/550 kawasaki jetski ( inquire)
    - engine mounts 440 / 550 / 650 / 750 /900 kawasaki $20 each
    - -stock waterboxes kawasaki 650 sx 650 x2 - $15
    - cdi from 650 sx - $90
    -stator 650 sx - $95
    - flywheel 650sx - $50
    - flywheel 750 sx 800 sxr etc ... $50
    - regulator 650 sx some 440 / 550 /// $?
    - complete 650 sx engine in need of rebuild .. it might run as is with included spare piston .. available as short block or long block
    - good 650 cylinder will need rebore ?

    more parts may be available just ask .. but NO i dont have everything !

    upper cowl from 750 / 900 ZXI model .. CHEAP get it out of my way - $20 !
    large front storage bucket and smaller rear - $20 ZXI
    speedo fuel gauge kawasaki zx i- $ ?
    650 engine plates - $10
    - mikuni aftermarket flame arestor adaptors 44 and 38 s ( four or 3 bolt models ) - $ 15 each
    - aftermarket 440 / 550 ride plate and intake grate .. $ 50 for both
    - 440 pump complete with SS impeller and shaft .. $ 70 .. or complete hull pole hood with pump shaft etc , etc $150
    - 440/550 gas tank hull front block off ..



    - My Kawasaki X2 hull also may be available NOT CHEAP .. also needs just engine ,pipe and electronics .. all other parts there and it has MANY MANY upgrades .. nice clean pump SS impeller UMI ish steering setup ( sort of ) .. bilge set up for duals .. one included with a kick ass switch set up .. motocross bars , chopped hull ,, etc etc $800
    buy my x2 and i will add a rebuildable long block 650 for $200

    no relays too many to go through but too many "iffy" relays

    Hamilton pick ups or canada post ..

    email ang4th@hotmail for prices .. some of my prices may be higher than you can find on other sites but within Canada lower shipping costs .. and when i am down to my last spares I tend to charge replacement cost on what it would cost me to replace including shipping .. based on murfeys law .. if i sell you my last spare part I will definatly need that part myself within the next weeK .. yea dont laugh I proved that to be true more than once ! so a part i may sell for 20 one week might be asking 30 the next ,,
    Last edited by Ang4th; 02-21-2012 at 01:59 PM.

  2. #2

    Default

    some parts
    Attached Thumbnails Attached Thumbnails DSC01328.jpg   DSC01305.jpg   DSC01967.jpg   DSC01975.jpg   DSC01966.jpg  


  3. #3

    Default

    more ..
    Attached Thumbnails Attached Thumbnails DSC01293.jpg   DSC01965.jpg   DSC01977.jpg   DSC01978.jpg   DSC01972.jpg  


  4. #4
    Member
    Location
    Slave lake AB
    PWC
    Newly acquired 1990 js440,
    Posts
    3

    Default

    Emailed you on parts for my ski let me know if you don't receive the email, thanks

Similar Threads

  1. Jetski Shipping in Canada
    By reidfrombj in forum General PWC Chat
    Replies: 3
    Last Post: 04-08-2012, 09:15 PM
  2. shipping seadoo from the U.S. or Canada?
    By dbdoo in forum General PWC Chat
    Replies: 2
    Last Post: 08-03-2010, 01:30 PM
  3. Best place in Canada to buy OEM seadoo parts
    By Seadoo-bear in forum Sea-Doo
    Replies: 5
    Last Post: 02-12-2007, 02:35 PM
  4. Attn. Chester
    By ColdFusion in forum General PWC Chat
    Replies: 6
    Last Post: 03-17-2006, 03:41 PM
  5. Source of aftermarket parts in Canada
    By Canuck in forum General PWC Chat
    Replies: 9
    Last Post: 03-01-2006, 02:54 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •