Results 1 to 5 of 5
Thread: race ski?
-
03-25-2013, 07:04 PM #1
- Location
- amherstburg ontario
- PWC
- 1996 HX
- Posts
- 4
race ski?
just bought a ski from the us that was used for receing he said,just wondering if wwe have races it would be good for and if it would work well,previously I have only had old skis that were lucky to hit 30mph I think this should be different
and take a little getting used to,the former owner said it was good for hole shots and would only do about 50mph top end?will this set up last? or will the higher compression kill it?built many race cars but this is my first venture into jetskis. specs below
1996 SEADOO HX with new rebuilt motor with less then 1 hour MANY MANY new parts
The HX was the premier sport ski by SEA DOO THe best wave jumper. Drop Nozzle can be reversed for XTREME AIR
R & D intake and exhaust manifolds
R & D Head
UMI Aluminum on?off
UMI Nerf Cusion
Factory wet expansion chamber and exhaust
NOVI carbs (paid 800)
Flyin Fish Intake
Hydraulic Drop Nozzle
R & D Finger throttle
New Jet Trim seat
New seat spring boot
New Hydroturf
New fuel lines
New Fuel Pump
Motor is ported
Premix set up for 92 octane
R & D Alumumim Race handle bars
Race instament cluster
PROX air cleaners
Fuel Primer
Water Router
Over $3000.00 in engine and hull mods ASKING ONLY $1500.00 OBO
Hull in great shape Ski was bought and COMPLETELY rebuilt with all the goodies WESCO all aluminumTrailer included
-
03-26-2013, 01:20 PM #2
- PWC
- 2003 Seadoo GTX 185 Supercharged
- Posts
- 65
I dont know any info about racing meets/events... But should be interesting if somebody post something here... I just hope to be lucky enough and watch one close to GTA...
-
03-26-2013, 01:21 PM #3
- PWC
- 2003 Seadoo GTX 185 Supercharged
- Posts
- 65
Welcome to the forum btw...
-
03-30-2013, 06:45 AM #4
- Location
- amherstburg ontario
- PWC
- 1996 HX
- Posts
- 4
the former owner of the ski says it was set for sea level,in windsor we are 622 ft above he says I might have to reset the timeing and adjust the carbs?do you think this is needed?it is a 787 with novi carbs is this hard to do?is there some one in the windsor area whom can do this?aprox cost?thanks.
-
03-30-2013, 11:07 AM #5
Similar Threads
-
I want to race?
By redgolem in forum General RacingReplies: 3Last Post: 11-20-2014, 11:35 PM -
hello from race tech in aurora
By race tech in forum New MembersReplies: 3Last Post: 10-07-2012, 02:42 PM -
race boats wanted
By henn in forum PWC - WantedReplies: 4Last Post: 03-25-2012, 04:37 PM -
Ontario Race shops?
By crxski in forum Sea-DooReplies: 3Last Post: 05-26-2009, 09:30 AM -
race course anyone?
By SideFX in forum British ColumbiaReplies: 20Last Post: 10-10-2008, 09:02 PM
Bookmarks